Charge Master...
Neighbour tells me that he never calibrates before using it. Doesn't zero either. He always checks the thrown load on a beam scale and it is always spot on. Doesn't wander.
I calibrate before each start. Never zero. Never wanders. Spot checks sometimes and it is always good.
Only thing I have noticed is the occasional extra kernal thown into the pan just as it is done, ah well, start again.
Powder dispensers?
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
HeatherW762
Re: Powder dispensers?
rox wrote:What sort of cyclic time are you getting to deliver a charge on the Lyman?HeatherW762 wrote:I know I'm a tad late on this post but my hubby just bought me a Lyman 1200DPS3 for Christmas and I'm over the moon about it. Lovely piece of kit and although I'm waiting for the rest of the kit (see next post) I have played with it and it's amazingly accurate.
For comparison, using a CM with tweaked parameters I get around 45gr of N140 dispensed approx every 23 secs - just longer than my cyclic seat-measure-box rate (single-stage).
Bob.
Will get back to you on that as I had to box it up again - nothing wrong just till I get everything else sorted. However, good news yesterday, Chris & I have treated ourselves to a hand built reloading bench, made to our spec, to fit in the spare room .... and it arrives on Monday - whoopee
Heather
Re: Powder dispensers?
That sounds like a plan, don’t forget to post a picture when it is built and all laid out.
Some of the wood arrived today for my new improved reloading area, the plan is to build it over the Xmas break, technically I wont get any extra bench space but storage will increase and lighting will be improved and during the summer I will be able to sit at the bench and get a lovely view of the garden.
Some of the wood arrived today for my new improved reloading area, the plan is to build it over the Xmas break, technically I wont get any extra bench space but storage will increase and lighting will be improved and during the summer I will be able to sit at the bench and get a lovely view of the garden.
-
Blu
Re: Powder dispensers?
Christel,
Blu
I just lift a couple of kernels out and then run the trickler until it's the right weight.Only thing I have noticed is the occasional extra kernal thown into the pan just as it is done, ah well, start again.
Blu
Who is online
Users browsing this forum: Google [Bot] and 0 guests