And Ovenpaa, your 'bottom line' applies to every other rifle/cartridge combination. Assume nothing!
Gaz - if you took a RUAG 308 round along to any gunsmith and said "rebarrel my rifle so it will chamber this cartridge." I honestly can't see any gunsmith buggering it up - that's his job!
TR chamber dimensions problem?
Moderator: dromia
Forum rules
Should your post be in Grumpy Old Men? This area is for general shooting related posts only please.
Should your post be in Grumpy Old Men? This area is for general shooting related posts only please.
-
The Gun Pimp
- Posts: 1154
- Joined: Fri Dec 10, 2010 3:08 pm
- Contact:
-
GazMorris
Re: TR chamber dimensions problem?
You have much more faith in gunsmiths than I do Vince!The Gun Pimp wrote:Gaz - if you took a RUAG 308 round along to any gunsmith and said "rebarrel my rifle so it will chamber this cartridge." I honestly can't see any gunsmith buggering it up - that's his job!
I have certain knowledge of a fair number of cockups (and have experienced one or two) that gunsmiths have made over the years, including failing to correctly re-barrel rifles with coned bolt faces which subsequently failed proof as a result, failing to crown a new barrel at all, stripping screws during routine work etc...There are a (small) number of gunsmiths who I will not lodge a rifle with under any circumstances.
Gaz
-
The Gun Pimp
- Posts: 1154
- Joined: Fri Dec 10, 2010 3:08 pm
- Contact:
Re: TR chamber dimensions problem?
Not good!
Who is online
Users browsing this forum: No registered users and 7 guests