Page 4 of 5
Re: DIY Swaging dies!
Posted: Wed Jun 13, 2012 2:50 pm
by dromia
See my reply to your question in your vendors forum.
Anyone wishing to reply to Joe please do so there not on this thread.
Here is the link to the appropriate thread for replies:
http://www.full-bore.co.uk/viewtopic.php?f=81&t=8121
Re: DIY Swaging dies!
Posted: Wed Jun 13, 2012 3:13 pm
by j0e_bl0ggs
Apologies for asking the question twice.
Re: DIY Swaging dies!
Posted: Fri Jun 15, 2012 2:27 pm
by j0e_bl0ggs
Here's a sample of fired brass, de-rim with swaged core and core seated + sized to 6mm.
Re: DIY Swaging dies!
Posted: Mon Jun 18, 2012 4:35 pm
by j0e_bl0ggs
Messing around with the reamer.
6mm bullet looks to be quite short so did not make an over long ogive.
Re: DIY Swaging dies!
Posted: Fri Jun 22, 2012 1:15 pm
by j0e_bl0ggs
First couple of 6mm samples...
Re: DIY Swaging dies!
Posted: Fri Jun 22, 2012 4:48 pm
by j0e_bl0ggs
A further selection with an earlier made .224
Re: DIY Swaging dies!
Posted: Mon Jun 25, 2012 4:40 pm
by j0e_bl0ggs
Complete set;
Re: DIY Swaging dies!
Posted: Tue Jun 26, 2012 4:49 pm
by j0e_bl0ggs
Core cutter;
Re: DIY Swaging dies!
Posted: Tue Jun 26, 2012 5:04 pm
by Sandgroper
When you get a chance, could you take us through the process. It would be much appreciated.
Re: DIY Swaging dies!
Posted: Sun Jul 15, 2012 7:30 am
by j0e_bl0ggs
Sandgroper wrote:When you get a chance, could you take us through the process. It would be much appreciated.
My client has promised to do a 'blow-by-blow'
When it is done I will ask him to post here...