Page 4 of 4
Re: Pin Gauges.
Posted: Thu Nov 24, 2011 6:19 pm
by Dougan
Owww, you saw through the joke - I was hoping for a well intentioned warning about not using the case....
...it's one of my 'loading mishaps' from earlier in the year.....
I can see I'll have to do better than that to get one over on you guys
Re: Pin Gauges.
Posted: Thu Nov 24, 2011 6:35 pm
by spud
Dougan wrote:Owww, you saw through the joke - I was hoping for a well intentioned warning about not using the case....
...it's one of my 'loading mishaps' from earlier in the year.....
I can see I'll have to do better than that to get one over on you guys
you must either:
a; get up ealier
or
b; must try harder
Re: Pin Gauges.
Posted: Fri Jan 06, 2012 8:13 am
by spud
I'm after a rail type system to traverse along so that i can run an angled dti tip in to a case neck.
David any ideas.
The rail must be as smooth as a nuns complxion and have movements of about 2 inches preferebly laterally although veticale can be do-able.
Anybody?
Re: Pin Gauges.
Posted: Fri Jan 06, 2012 8:40 am
by ovenpaa
Building a ramp is easy enough, I machined a 22 minute rail a while ago, can you email/PM me a sketch?
Re: Pin Gauges.
Posted: Fri Jan 06, 2012 9:25 am
by spud
Nice one thanks.
