Re: Best 600 mard 308 bullet
Posted: Tue Jul 19, 2016 7:03 pm
Alcobullets ? What kind of proof test are they subject to ? Are they available off-license ?
The UK's Finest Independent Forum for Shooters and Gun Owners. Est 2010.
All people seeking membership must contact admin after registering to be validated.
https://www.full-bore.co.uk/
Best 600 mard 308 bullet
Page 4 of 5
Re: Best 600 mard 308 bullet
Posted: Tue Jul 19, 2016 7:05 pm
Our 240 gn. gas checked, cast lead bullets, acquired from Dodgyrog of this parish, are going to be fired from a 1 in 8 inch twist barrel...
Re: Best 600 mard 308 bullet
Posted: Tue Jul 19, 2016 7:09 pm
I would do a QC check on them regardless of source, at least weigh them into batches, if you are serious about good groups.
Re: Best 600 mard 308 bullet
Posted: Tue Jul 19, 2016 7:18 pm
They are available but I had to get an ITAR licence so not easy. Weight all 155.2 or 155.3 length from base to ogive all the same.meles meles wrote:Alcobullets ? What kind of proof test are they subject to ? Are they available off-license ?
I'll be doing so tests in the next few weeks
Re: Best 600 mard 308 bullet
Posted: Tue Jul 19, 2016 7:20 pm
Are they best served with ice and a splash of tonic?
Re: Best 600 mard 308 bullet
Posted: Tue Jul 19, 2016 7:35 pm
Pimsmeles meles wrote:Are they best served with ice and a splash of tonic?
Re: Best 600 mard 308 bullet
Posted: Tue Jul 19, 2016 8:46 pm
meles meles wrote:Our 240 gn. gas checked, cast lead bullets, acquired from Dodgyrog of this parish, are going to be fired from a 1 in 8 inch twist barrel...
A ha , faster than normal for a 308
Good luck , I admire people who make there lives difficult for no reason
Re: Best 600 mard 308 bullet
Posted: Wed Jul 20, 2016 7:44 am
It is only difficult to those that don't have the capacity and knowledge as to how to do it.
Re: Best 600 mard 308 bullet
Posted: Wed Jul 20, 2016 8:45 am
And if it were easy, sticky, the head cases would be at it...
Re: Best 600 mard 308 bullet
Posted: Wed Jul 20, 2016 9:03 am
looking forward to seeing you re-invent the wheel