It does as they are both .311"saddler wrote:
The SMK bullet for the .303 is supposed to work well in the 7.62x54.
Pulling surplus ammo
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
snayperskaya
- Posts: 7234
- Joined: Fri Oct 04, 2013 6:43 pm
- Home club or Range: West Bank of the Volga.....
- Location: West of The Urals
- Contact:
Re: Pulling surplus ammo
"The only real power comes out of a long rifle." - Joseph Stalin
Give a man a gun and he can rob a bank.....give a man a bank and he can rob the world!.
More than a vested interest in 7.62x54r!
Give a man a gun and he can rob a bank.....give a man a bank and he can rob the world!.
More than a vested interest in 7.62x54r!
Who is online
Users browsing this forum: No registered users and 5 guests