I pretty much stick to Redding bushing neck sizers (OD)..... if I need to do anything to the ID of the neck I use a K&M mandrel with a smear of Imperial sizing waxdromia wrote:Die castration, way to go.
Just out of interest does anyone use the expander balls on their dies? As i said I don't as they seemed to cause more problems than they were worth.
Lubing the inside of case necks
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
DaveT
Re: Lubing the inside of case necks
Who is online
Users browsing this forum: No registered users and 5 guests