I use the same sort of tool in my lathe it takes seconds to remove the crimp.Oddbod wrote:OK so I'm a savage: I use the pointy nose on my RCBS case neck deburring tool to remove primer pocket crimps.
Primers not going into some GGG .223 cases
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Re: Primers not going into some GGG .223 cases
-
shugie
- Posts: 1602
- Joined: Sun Apr 29, 2012 3:42 pm
- Home club or Range: Sperry at Bisley
- Location: near Reading
- Contact:
Re: Primers not going into some GGG .223 cases
It does, are they not strong enough?channel12 wrote:Remington say don't use their 6 1/2 small rifle primers in .223. There is a warning (in very small print!) on the edge of box.
Careful now/that sort of thing
-
Daryll
- Posts: 1048
- Joined: Sat Jun 14, 2014 9:07 am
- Home club or Range: Isle Target Sports Club
- Location: Cambridgeshire
- Contact:
Re: Primers not going into some GGG .223 cases
I seem to remember a thread somewhere, I thought on this forum, about primers and .223... basically the CCI 400 are not recommended either.
I think someone was getting flattened and pierced primers with moderate loads.
Edit: Found the thread...it does mention the Rem 6 1/2 not being suitable..
https://www.full-bore.co.uk/viewtopic.p ... it=primers
I think someone was getting flattened and pierced primers with moderate loads.
Edit: Found the thread...it does mention the Rem 6 1/2 not being suitable..
https://www.full-bore.co.uk/viewtopic.p ... it=primers
Who is online
Users browsing this forum: No registered users and 2 guests