Hi
It's been slugged, and cast. It shoots well, it's the consistency of the cast bullets at the driving band I want. The bullets can vary up to 3 thou.
Lubesizing Die for Martini Henry
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
dromia
- Site Admin
- Posts: 20221
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Lubesizing Die for Martini Henry
You could ask in the wanted section if any of the scrap grinders on here could open one out for you and fashion a new ejector pin.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
Re: Lubesizing Die for Martini Henry
https://www.reloading.org.uk/martini_henry.htm
Click on the link and scroll down until you come to resizing die.
He sells them they are not cheap.
Opening up a smaller diameter is not a easy task they are hardened.
Click on the link and scroll down until you come to resizing die.
He sells them they are not cheap.
Opening up a smaller diameter is not a easy task they are hardened.
-
Vossie
- Full-Bore UK Supporter
- Posts: 315
- Joined: Mon Oct 30, 2017 2:53 pm
- Home club or Range: Bisley
- Location: South East
- Contact:
Re: Lubesizing Die for Martini Henry
Cheers Alpha1 I have contacted him.
Re: Lubesizing Die for Martini Henry
Glad I could help. 
Who is online
Users browsing this forum: No registered users and 7 guests