Hand priming tool

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
User avatar
Mattnall
Full-Bore UK Supporter
Posts: 2940
Joined: Wed Mar 06, 2013 5:32 pm
Home club or Range: NRA, Redricks TSC, BS1944RC, HRA
Location: East Herts
Contact:

Re: Hand priming tool

#11 Post by Mattnall »

rox wrote:
waterford103 wrote:Yes I eagerly buy any used round Lee handprimers . I bought one of the square ones and used some of the bits to fix my round one , the rest went in the bin.
Brilliant! Thanks for this. Didn't realise I could resurrect my broken one and ditch the square POS!

..
Yep, I've had the Lee round hand primer for 30 years or so, and must have primed hundreds of thousands of cases over the years, never failed me and ir is easy to swap between cartridge and primer sizes.
Arming the Country, one gun at a time.

Good deals with Paul101, Charlotte the flyer, majordisorder, Charlie Muggins, among others. Thanks everybody.
Post Reply

Who is online

Users browsing this forum: Bing [Bot] and 2 guests