This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
[quote="Laurie] I'm currently doing a three part test / review of SR primer performance in Target Shooter online with parts 1 and 2 published and the conclusions / results in part 3 going live in the next week or 10 days.
If you look at Part 2 you'll find a pic of some Rem 6 1/2s which have nearly failed in a 308 Win 'Palma' brass load which QuickLOAD estimates at around 58,000 psi - some 4,000 below SAAMI maximum. The CCI-400s produced examples that had cratered almost as badly. Other models either cratered slightly or showed no damage at all. These were fired in a rifle with a Stolle Atlas F-Class type action that will reduce metal stress through lack of cup support much better than many factory actions[/quote]
