phaedra - but why would ya? Why waste primer, bullet and powder just to end up with an inferior case and no saving in cost? Not to mention going to the range to fire-form.
Fox Firearms have Lapua 6.5 Creedmoor in stock for £97/100 - where's the saving?
hornady neck sizing 6.5
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
The Gun Pimp
- Posts: 1154
- Joined: Fri Dec 10, 2010 3:08 pm
- Contact:
-
Gerry939
Re: hornady neck sizing 6.5
Got a reply from Hornady that there 6.5 (.264 )neck sizing dies are ok for my creedmoor, just ordered one from Dauntsey Guns , I think this discussion could go on for a while, will try neck sizing and see if there are any benefits thanks 
-
phaedra1106
- Posts: 3429
- Joined: Wed Feb 08, 2012 9:37 pm
- Location: Just outside Sacriston (the nice bit!)
- Contact:
Re: hornady neck sizing 6.5
How is it a waste?, I just fire formed 120 RWS 243 into 260 Rem, they all grouped very nicely under 1". The once fired 243 and 22-250 cases cost me about £23/100, nothing inferior about the resulting cases, they work perfectly.The Gun Pimp wrote:phaedra - but why would ya? Why waste primer, bullet and powder just to end up with an inferior case and no saving in cost? Not to mention going to the range to fire-form.
Fox Firearms have Lapua 6.5 Creedmoor in stock for £97/100 - where's the saving?
There's room for all Gods creatures, next to the mash and gravy :)
Who is online
Users browsing this forum: No registered users and 3 guests