Parker Hale T4

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
dromia
Site Admin
Posts: 20226
Joined: Sat Nov 06, 2010 4:57 am
Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
Location: Sutherland and Co Durham
Contact:
Contact dromia

Re: Parker Hale T4

#11 Post by dromia »

Take a Dremel to the shell holder.
Image

Come on Bambi get some

Imperial Good Metric Bad
Analogue Good Digital Bad

Fecking stones

Real farmers don't need subsidies

Cow's farts matter!

For fine firearms and requisites visit
http://www.pukkabundhooks.com/
Top
User avatar
dodgyrog
Posts: 4103
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:
Contact dodgyrog

Re: Parker Hale T4

#12 Post by dodgyrog »

Rockhopper wrote:Well I bit the bullet (so to speak) and ended up buying a Lee Challenge Kit with two sets of collet dies for .308 and .303

The shop only had PPU .308 cases - I'm slightly disappointed that only just under half of them fit easily into the shell holder, the others have to be knocked in with a screwdriver handle or similar. Is that typical of PPU or is something wrong?
Use a No 3 shell holder
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
Top
Rockhopper
Posts: 912
Joined: Mon Nov 09, 2015 2:36 pm
Contact:
Contact Rockhopper

Re: Parker Hale T4

#13 Post by Rockhopper »

I'll give that a try, thanks.
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: No registered users and 4 guests