Reloading Used Cases
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Re: Reloading Used Cases
I asked because I have a few boxes of shot nickel plated Winchester 38 Spl cases that I have been saving for whatever reason and wondered if they would shoot in a 357.
-
dromia
- Site Admin
- Posts: 20224
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Reloading Used Cases
I would and do.
With the cleaning and velocity caveats of my previous post.
With the cleaning and velocity caveats of my previous post.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
-
phaedra1106
- Posts: 3429
- Joined: Wed Feb 08, 2012 9:37 pm
- Location: Just outside Sacriston (the nice bit!)
- Contact:
Re: Reloading Used Cases
Another to add that PPU pistol brass is absolute pants, bought 100 .44mag and around 20% have been tossed due to splitting, some only a mm or two others almost the full case length, I stress that these have never been loaded to "factory" loads only with 5.4gr of TiteGroup which is an excellent plinking load.
As has been said just make sure if you're buying "once fired" it actually is, I bought a lot of .223 off a member and most of it ended up in the bin, over chamfered and over sized primer flash holes, a huge mix of manufacturers and ages and a lot with military primer crimps. I can also vouch for Johns RWS brass, first class stuff indeed.
If you're looking for pistol calibre brass then spend the few extra £s and buy new Starline cases, superb quality.
As has been said just make sure if you're buying "once fired" it actually is, I bought a lot of .223 off a member and most of it ended up in the bin, over chamfered and over sized primer flash holes, a huge mix of manufacturers and ages and a lot with military primer crimps. I can also vouch for Johns RWS brass, first class stuff indeed.
If you're looking for pistol calibre brass then spend the few extra £s and buy new Starline cases, superb quality.
There's room for all Gods creatures, next to the mash and gravy :)
Who is online
Users browsing this forum: No registered users and 6 guests