TR140 Ignition woes

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
Steve E

Re: TR140 Ignition woes

#11 Post by Steve E »

TR140 being a tad slower than N140 (but faster than N150) can fill the case better. Since moving to TR140 I have been able to get higher velocities at lower pressures than N140.(My loads have been to the proof house) In both .308 and .303 i have seen group sizes reduce, in the case of .303 a rifle that was shooting 2moa groups at 600yds is now shooting under 1moa out to 1000yds. So is TR140 a replacement for N140? in my opinion yes. Its also cheaper and I buy it in 2.5 Kgs at a time so make a bigger saving. So much so, that the only powder that i will use for .308 and .303 is TR140. Bye Bye Vit N140.




Steve
User avatar
phaedra1106
Posts: 3429
Joined: Wed Feb 08, 2012 9:37 pm
Location: Just outside Sacriston (the nice bit!)
Contact:

Re: TR140 Ignition woes

#12 Post by phaedra1106 »

Can I ask who sells it in 2.5Kg size?, I got 5x1Kg and am going through it quite rapidly!
There's room for all Gods creatures, next to the mash and gravy :)
ukrifleman
Full-Bore UK Supporter
Posts: 756
Joined: Thu Jun 07, 2012 7:26 pm
Contact:

Re: TR140 Ignition woes

#13 Post by ukrifleman »

Problem solved! I loaded up some more test loads using the same load of 38g of TR140 behind a 198g .323 dia FMJBT bullet but this time I used Federal mag primers; 38g of TR140 occupies about 2/3rds of the case capacity, so there shouldn't be the case of the charge leaving the flash hole exposed.

Every round performed perfectly with a clean burn. The load is on the mild side, indicated by the primers backing out a little, but accurate and with clean brass.
There is scope for increasing the performance of the round (8mm Lebel) but as the carbine is over a 100 years old and the round performs well, I don't see the need.
I was able to knock down fig 11's at 300 yards with no problem today.

TR140 powder is Swiss made not Finnish.

ukrifleman
User avatar
shotgun sam
Posts: 542
Joined: Mon Jan 30, 2012 6:42 pm
Location: South Lanarkshire, Scotland
Contact:

Re: TR140 Ignition woes

#14 Post by shotgun sam »

is there a website for the makers of tr140? if so can you list it please.

Sam
mossberg 500
meteor mk2
smk 19 (0.22)
ruger 12/22 stainless synthetic 22lr
cz 452 style 16 inch 22lr
tikka t3 lite stainless 223
308 howa 1500 varmint
BSA Lightning XL (0.22)
Lanber Over and Under
Baikal mp153
AYA Cosmos 410
1917 BSA SMLE 303
User avatar
ovenpaa
Posts: 24689
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: TR140 Ignition woes

#15 Post by ovenpaa »

0589.EXP.5841/03
(ammendment no. 1) WLP 220 (P-Code 0254)

Propellant 11-03-15 Applicant:
Nitrochemie Wimmis AG
Niesenstraße 44
3752 Wimmis
Schweiz

Das Treibladungspulver WLP 220 (P-Code 0254) kann auch unter dem Handelsnamen TR140 vertrieben werden.
The last bit states 'The propellant WLP 220 (P-code 0254) may be sold under the trade name TR140'
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests