i could be up for one of these swaging presses cost dependant..........
greenshoots
Swaging press
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Re: Swaging press
I can build them, it is however quite a project. If I could raise interest for say 5 or even better 10 then it would make it worth while.
-
saddler
Re: Swaging press
Excellentstalker wrote:Saddler you wanted wamadet swaging instructions.
Here they are.Hope this is useful.
I have press and slube instructions also.
BUT
Cannot open them for some reason.
Any chance of a PM or e-mail of them?
EDIT:
Managed to open them...BUT = anyone have pics of what the swage dies look like & how they are assembled?
As I said, I have a few extra parts with one of the Wamadets, but not sure what these are until I can see photos, etc.
Many thanks for the help
Last edited by saddler on Fri Feb 17, 2012 12:07 pm, edited 1 time in total.
-
saddler
Re: Swaging press
MAY be keen, but as with everything else sadly....depends on the price
-
stalker
Re: Swaging press
Saddler have taken photos. but upload time seems very long,i must be doing something wrong. Give me your email and i will send direct.
-
Christel
- Site Admin
- Posts: 17530
- Joined: Fri Nov 05, 2010 7:52 pm
- Location: Wind Swept Denmark
- Contact:
Re: Swaging press
5 or more posts are needed in order to use the PM system 
-
saddler
Re: Swaging press
...so near yet so far!christel wrote:5 or more posts are needed in order to use the PM system
-
Christel
- Site Admin
- Posts: 17530
- Joined: Fri Nov 05, 2010 7:52 pm
- Location: Wind Swept Denmark
- Contact:
Re: Swaging press
saddler wrote:...so near yet so far!christel wrote:5 or more posts are needed in order to use the PM system
Stalker....post something
Who is online
Users browsing this forum: No registered users and 4 guests