Afternoon all,
I have been following Dave's "next project" thread and have to admire the ingenuity of it all but it got me thinking if there was a different way of applying heat to the cases that is both financially viable and controllable-blow torches just seem a little bit hit and miss. I have been looking into the feasibility of adopting an Induction coil system instead but without the required knowledge of the electrical side of things, I just don't know if it would be worth pursuing? Anyone out there that knows about these things as they certainly look like they could be applied to the brass annealing process.
One for the electrical engineers out there
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
Meaty
- Posts: 1109
- Joined: Mon Feb 07, 2011 1:02 pm
- Home club or Range: Grove Small Arms.Thetford Gallery, STANTA, Barton Road
- Location: Norfolk
One for the electrical engineers out there
"There are four boxes to be used in the defence of liberty: soap, ballot, jury and ammo. Please use in that order."
Re: One for the electrical engineers out there
There are a good few induction annealers out there - Here's one that shows promise.
http://www.youtube.com/watch?v=Ny0a72_AX0E
http://www.youtube.com/watch?v=Ny0a72_AX0E
Re: One for the electrical engineers out there
That is very nice, I have looked at induction heaters in the past but they are expensive and scary things and I just know I would have to out my finger in it to see what happens.... 
Re: One for the electrical engineers out there
Have you guys seen this one? There's a video on the page as well. http://www.giraudtool.com/annealer1.htm
Blu
Blu
Re: One for the electrical engineers out there
Thats another interesting twist - As far as I understand they can't/won't send them over here. The bulk filling set-up seems to upset the authorities.Blu wrote:Have you guys seen this one? There's a video on the page as well. http://www.giraudtool.com/annealer1.htm
Blu
Who is online
Users browsing this forum: No registered users and 0 guests