.410 Slug Mould
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
.410 Slug Mould
A friend of mine is trying to start loading .410 slugs. Is there a mould that anyone would recommend just for target shooting at 25 yards or so?
-
mag41uk
- Posts: 1847
- Joined: Sat Oct 13, 2012 3:50 pm
- Home club or Range: Aldershot R & P Club
- Location: Reading
- Contact:
Re: .410 Slug Mould
You can use a 41 swc with the nose glued into a plastic wad.
The wad acts as a tail and you are in effect shooting a wadcutter bullet.
You may need to check the choke size.
The wad acts as a tail and you are in effect shooting a wadcutter bullet.
You may need to check the choke size.
Re: .410 Slug Mould
Oh thank you that's really helpful information.
Who is online
Users browsing this forum: Google [Bot] and 3 guests