Hornaday dies

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
Stu.......

Hornaday dies

#1 Post by Stu....... »

Hi everyone I've been loading for a while for my .243 win I recently bought a .222 rem and so started loading for that too, however when I resize the cases the die is leaving a ridge at the bottom of the case sometimes with quite a sharp edge, not sure what's going on as the hornaday dies were ok in .243
Any ideas
Thanks
Also the cases don't seem to be damaged as such so I'm thinking they'll be ok to fire?
Image

Sent from my Pixel 2 using "An application"
Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests