Anyone use a Lyman Mag25 melting furnace? Comments good or bad welcome.
Redcat
Lyman mag25
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
redcat
- Full-Bore UK Supporter
- Posts: 1426
- Joined: Fri Jan 16, 2015 11:42 am
- Home club or Range: Teesdale P&R Club.
- Contact:
Lyman mag25
If you think you are a person of some importance, try ordering someone else's dog around.
-
dromia
- Site Admin
- Posts: 20229
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Lyman mag25
They are still relatively new but so far the reports have been positive. I was going to get one when they came out but as usual none available here so I went with Stephans 40lbers. Best pots out there bar none.
The only concern I would have is the PID being built next to the crucible and contained within the housing, the electrics don't like heat so that could be a an issue in waiting.
The RCBS Easymelt has a really long shut down cycle because of this.
The only concern I would have is the PID being built next to the crucible and contained within the housing, the electrics don't like heat so that could be a an issue in waiting.
The RCBS Easymelt has a really long shut down cycle because of this.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
Who is online
Users browsing this forum: No registered users and 0 guests