Get a lyman "M die"....
Mike95
Tight neck size
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
Martin
Re: Tight neck size
It would be tight under hand pressure. To get a better understanding, measure the neck diameter of a loaded round. As a very rough guide, given where you are in terms of your handloading experience, your resized case neck should be around 0.002 inches less.Ferrari27 wrote:Hi, New to reloading, first attempt!
.... its a very tight fit. Is this normal?
This might assist:
http://www.6mmbr.com/JGcaseprep.html
Who is online
Users browsing this forum: No registered users and 7 guests