Reloading for an Underlever..
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
falco67
Re: Reloading for an Underlever..
I did think that, but its 1.600 which it should be, as far as I am aware.
-
phaedra1106
- Posts: 3429
- Joined: Wed Feb 08, 2012 9:37 pm
- Location: Just outside Sacriston (the nice bit!)
- Contact:
Re: Reloading for an Underlever..
Load it to the cannelure, 1.610" is the max Saami length (min is 1.535") anywhere in between is fine. COAL for my 200gr is 1.535" and my 245gr is 1.583"
There's room for all Gods creatures, next to the mash and gravy :)
-
falco67
Re: Reloading for an Underlever..
Thanksphaedra1106 wrote:Load it to the cannelure, 1.610" is the max Saami length (min is 1.535") anywhere in between is fine. COAL for my 200gr is 1.535" and my 245gr is 1.583"
crimping to the bullet canulure gives me a COAL of 1.557
Who is online
Users browsing this forum: No registered users and 3 guests