Forming 22-250 from 6.5x47
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Forming 22-250 from 6.5x47
Has anyone tried forming 22-250 brass from 6.5x47, I ask because I am still curious to see if the small primer would make any difference to the 22-250.
-
takbok
Re: Forming 22-250 from 6.5x47
Did you manage to do this? Maybe the Lapua 6.5 Creedmoor brass would work.
Re: Forming 22-250 from 6.5x47
Not tried it yet as I have been shooting my 6,5x47 however the mighty -250 needs to come out again. Good point about he 6,5CM I will see if I can find a few.
Who is online
Users browsing this forum: No registered users and 7 guests