I am about to reload some 8x57IS with 225 grain gas checked cast bullets and I have the following powders in reasonable quantities, can anyone recommend one to start with please? The rifle will be used for up to 100m and then 300m so two separate loads is fine and I do not want to end up with a bruised shoulder!
Accurate 5744
Alliant 2400
Hodgdon 380
Hodgdon 777
Hodgdon H414
Hodgdon H4831
Hodgdon H4895
Hodgdon Little Gun
Hodgdon Long Shot
Hodgdon Tight Wad
Hodgdon Varget
IMR Trailboss
Ramshot X-Terminator
Reload Swiss RS50/TR140
Vectan SP9
Vectan TU5000
Viht N140
Viht N160
Viht N310
Viht N540
Viht N550
Viht N560
Reloading the 8x57IS - cast bullets
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
WelshShooter
- Full-Bore UK Supporter
- Posts: 1812
- Joined: Wed Jun 25, 2014 9:45 pm
- Contact:
Re: Reloading the 8x57IS - cast bullets
I believe Accurate 5744 (or Lovex D060)would be a good choice of powder for low recoil loads. I've used this powder with .303 174gr FMJ bullets and while they were not superbly accurate, they reduced recoil by a significant amount and are perfect for short ranges. However, I do not have any loading data for 8x57 IS with this powder so you may have to consult QuickLoad.
You may want to consult "the workhouse load" which is discussed in a sticky within the library, however, this might not cover >200gr bullets if memory serves:
http://full-bore.co.uk/viewtopic.php?f=36&t=810
You may want to consult "the workhouse load" which is discussed in a sticky within the library, however, this might not cover >200gr bullets if memory serves:
http://full-bore.co.uk/viewtopic.php?f=36&t=810
-
dodgyrog
- Posts: 4103
- Joined: Wed Jan 05, 2011 11:17 pm
- Home club or Range: Three Counties Sporting Club & Gardners Guns
- Location: Consett, County Durham
- Contact:
Re: Reloading the 8x57IS - cast bullets
I would think a starting load of around 22gr 5744 and work up from there
Or 16gr 2400
Or 16gr 2400
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
All round good guy and VERY grumpy old man.
-
legs748
- Posts: 240
- Joined: Sat Jul 07, 2012 1:08 pm
- Home club or Range: Mattersey R&PC
- Location: North Nottinghamshire
- Contact:
Re: Reloading the 8x57IS - cast bullets
Is there a vhit equivalent for alliant 2400? I want to get started on my cast bullet experiments but I want to avoid American powders if I can to get round any supply issues. Burn chart in lyman cast bullet book puts 2400 between n110 and n350.
It was working when i left it...........
Re: Reloading the 8x57IS - cast bullets
N110 is quite close to A400 according to my powder burn rate chart
-
mag41uk
- Posts: 1847
- Joined: Sat Oct 13, 2012 3:50 pm
- Home club or Range: Aldershot R & P Club
- Location: Reading
- Contact:
Re: Reloading the 8x57IS - cast bullets
I would use 5744.
And N120 is a very good cast bullet powder.
And N120 is a very good cast bullet powder.
-
ukrifleman
- Full-Bore UK Supporter
- Posts: 757
- Joined: Thu Jun 07, 2012 7:26 pm
- Contact:
Re: Reloading the 8x57IS - cast bullets
I use Reloader7 in preference to Lovex DO60/5744 for all my cast loads, as I find it burns cleaner.
ukrifleman.
ukrifleman.
Who is online
Users browsing this forum: Jorden and 5 guests