Just checked that leaves the neck wall thickness about .012 in imperial.
Should i back of slightly with the neck trimming and try to find the maximum neck thickness that will still chamber?
I am only using this round at subsonic velocity, 13.5 grains of 2400 so pressure will not be high. Anyone with QL?
What is the learned opinion?
Rounds won't chamber
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
wildrover77
- Posts: 268
- Joined: Fri Nov 19, 2010 4:04 pm
- Location: Scarborough
- Contact:
Who is online
Users browsing this forum: No registered users and 5 guests