New to Reloading

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
User avatar
snayperskaya
Posts: 7234
Joined: Fri Oct 04, 2013 6:43 pm
Home club or Range: West Bank of the Volga.....
Location: West of The Urals
Contact:

Re: New to Reloading

#11 Post by snayperskaya »

Rockhopper wrote:
I started off with a Lee Loader for .303 - its a good tool and its great for .303 as it neck sizes only but its slow and noisy as you have to use a hammer. I quickly upgraded to a Lee Classic press (more expense!!).
I'm using a Lee Loader for 54r and it is quite satisfying to use, I prime the cases with a Lee Autoprime, and once you get a rhythm going it is quite quick.I do one round at a time from start to finish so as not to get any mix ups and I went with the Lee Loader as I am only reloading the one calibre and only small batches at a time.
"The only real power comes out of a long rifle." - Joseph Stalin

Give a man a gun and he can rob a bank.....give a man a bank and he can rob the world!.

More than a vested interest in 7.62x54r!
Duey
Posts: 343
Joined: Thu Feb 11, 2016 6:33 pm
Home club or Range: Offas Dyke, Pickering, North Cotes Butts and Grove small arms
Location: Brookenby, Lincolnshire

Re: New to Reloading

#12 Post by Duey »

Can also become very addictive and all consuming if your not careful wallhead
User avatar
flamoudi
Full-Bore UK Supporter
Posts: 113
Joined: Fri Jul 15, 2016 4:18 pm
Home club or Range: CVPC Ashgill Scotland
Location: Falkirk Scotland
Contact:

Re: New to Reloading

#13 Post by flamoudi »

Reloading full bore has it's benefits.

Not so much if you are hunting but a must for serious target shooting at distance.

It helps you tune your ammo to your gun and improves the accuracy if done right. It can be, as the previous comment, very addictive.

Spend a few hours watching YouTube videos and see how much is involved. It's not cheap to get started and components have risen in costdramayically in the last few years.

If you are a serious shooter you will end up reloading, seems unavoidable!
FredB
Posts: 969
Joined: Fri Dec 10, 2010 8:33 pm
Home club or Range: stourport
Location: Wolverhampton
Contact:

Re: New to Reloading

#14 Post by FredB »

The cost argument comes down to a choice of bullet and calibre. The above comments are correct it you shoot jacketed or even shop bought lead bullets in your chosen calubres. However, if you cast your own and shoot gallery rifle in pistol calibres, the cost savings are massive. If, like me, you shoot mainly obsolete calibres, then you have no choice. I shoot a lot of 310 Cadet and this works out cheaper than shooting .22 once you have the cases.
Fred
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests