Anyone used these .311" cast bullets???.

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
snayperskaya
Posts: 7234
Joined: Fri Oct 04, 2013 6:43 pm
Home club or Range: West Bank of the Volga.....
Location: West of The Urals
Contact:

Anyone used these .311" cast bullets???.

#1 Post by snayperskaya »

http://www.shellhousebulletcompany.co.u ... ow/6208547

Anyone got any experience of these?.
"The only real power comes out of a long rifle." - Joseph Stalin

Give a man a gun and he can rob a bank.....give a man a bank and he can rob the world!.

More than a vested interest in 7.62x54r!
saddler

Re: Anyone used these .311" cast bullets???.

#2 Post by saddler »

Phaedra uses their stuff & seems to like it.
Not sure if that particular boolit though...
User avatar
snayperskaya
Posts: 7234
Joined: Fri Oct 04, 2013 6:43 pm
Home club or Range: West Bank of the Volga.....
Location: West of The Urals
Contact:

Re: Anyone used these .311" cast bullets???.

#3 Post by snayperskaya »

saddler wrote:Phaedra uses their stuff & seems to like it.
Not sure if that particular boolit though...
Cheers Mr S......to be honest they are cheap enough to give these bullets a try.
"The only real power comes out of a long rifle." - Joseph Stalin

Give a man a gun and he can rob a bank.....give a man a bank and he can rob the world!.

More than a vested interest in 7.62x54r!
User avatar
phaedra1106
Posts: 3429
Joined: Wed Feb 08, 2012 9:37 pm
Location: Just outside Sacriston (the nice bit!)
Contact:

Re: Anyone used these .311" cast bullets???.

#4 Post by phaedra1106 »

Not those ones, I use the 165gr without gas checks for subsonic loads, very nice indeed :)

http://www.shellhousebulletcompany.co.u ... ow/4199927
There's room for all Gods creatures, next to the mash and gravy :)
polemass

Re: Anyone used these .311" cast bullets???.

#5 Post by polemass »

I used some .38sp 148g for my revolver-very nice groups,but only when loaded up side down....top service company-I was very pleased!
Livefast

Re: Anyone used these .311" cast bullets???.

#6 Post by Livefast »

I've used a fair few of their products from balls to boolits and have always found them excellent, if you buy some keep us posted on the results, i've been looking for a new cast example to try out.
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests