thinking of trying a new powder
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Re: thinking of trying a new powder
I did experiment with N140 and TR140/RS50 and Varget gave me the best results (26" Border barrel on an AI) for me is is a perfect load and I am justa bout to start testing with 129 grain Hornady Interlocks and again Varget will be my starting point.
Re: thinking of trying a new powder
Just looked back at my reloading notes, I did see higher MV's with other powders however my most accurate load was with Varget, disappointingly the most accurate load gave me a couple of pierced primers over 50 odd shots so I would back by 0.1 grains and no further primer issues and accuracy was there or thereabouts the same when tested at 100/600/1000 yards. Also it was Varget that gave the best results at 1200 yards.
If nothing else it did add fuel to my theory that fastest is not necessarily bestest
If nothing else it did add fuel to my theory that fastest is not necessarily bestest

- WelshShooter
- Full-Bore UK Supporter
- Posts: 1812
- Joined: Wed Jun 25, 2014 9:45 pm
- Contact:
Re: thinking of trying a new powder
Tell me more about this pointing die. What is its purpose? What effect does it have down range? Is it literally a die to ensure all open tip bullets have the same tip?Ovenpaa wrote:I shoot the 6,5X47 with 123 Scenars which are run through a pointing die and I use Varget exclusively with them and CCI magnum primers. It gets the job done rather wellnearly there wrote:It's 6.5X47 with 123 grain heads.I can get a few tubs of varget which will last me a good while.thanks
- dodgyrog
- Posts: 4103
- Joined: Wed Jan 05, 2011 11:17 pm
- Home club or Range: Three Counties Sporting Club & Gardners Guns
- Location: Consett, County Durham
- Contact:
Re: thinking of trying a new powder
Use 160 in that calibrenearly there wrote:Hi I reload for my 6.5 with 1 in 8 twist with rl15 but have been told I should try n140 or varget.is there any real gains or losses.if so what.thanks
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
All round good guy and VERY grumpy old man.
Re: thinking of trying a new powder
It is a die that has a sleeve and insert designed to uniformly close the meplat's down on bullets. This should offer an improvement to the BC and downrange performance and my findings at 1000 yards are a vertical gain of around 0,25mils/0.8MOA and a a slight improvement on horizontal so in theory it shoots slightly flatter and gives small wind gains. What I have also noticed is I see less 'flyers' and generally better groups at distance.WelshShooter wrote:Tell me more about this pointing die. What is its purpose? What effect does it have down range? Is it literally a die to ensure all open tip bullets have the same tip?
Re: thinking of trying a new powder
Been doing a lot of reading up and quizzing other shooters at my club and Varget is what they're all using on their F-Class 6.5x47 set ups. With 123g Scenars aswell
Who is online
Users browsing this forum: No registered users and 2 guests