This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Alpha1 wrote:I also check every case with a torch before seating the bullet it only takes a minute but it can save you a lot of grief. I don't use any bodies hand loads except my own. I'm mentoring a probationary member of our club at the moment he is a new shooter all though I have known him for several years. I'm taking him through the basics of reloading on a one to one basis. Its good because I'm having to do every thing from scratch its reminding me that I should not take anything about reloading for granted no matter how long you have been at it or how experienced you may think you are one mistake is a mistake to many.
Good advice, no matter how you reload every case should get a visual for correct powder charge, I set up this simple light, it's a flexible LED light from the pound shop and a rechargeable battery. Saves holding a torch.