Breaking down pinfire ammunition
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Breaking down pinfire ammunition
I have been given a handful of live 5mm pinfire ammunition and I am curious to see how they break down, has anyone pulled pinfire apart in the past?
Re: Breaking down pinfire ammunition
Yes, I've taken them apart in the past. I started by easing out the bullet (it was already loose) It was a heeled bullet, like a .22lr but about 7mm. The black powder was very fine and compacted. The case was totally rimless and made of copper. The firing pin was about the size of an old gramophone needle and the percussion cap, inside the case was brass.
In hindsight it might have been better to draw the firing pin first, it was just a push fit in the side of the case but as the bullet was loose that was an easy option.
In hindsight it might have been better to draw the firing pin first, it was just a push fit in the side of the case but as the bullet was loose that was an easy option.
Re: Breaking down pinfire ammunition
Thanks for the tips 1066 - I will pull one apart tomorrow for the printers case. It will be interesting to see if the black powder has any go left in it.
Who is online
Users browsing this forum: No registered users and 10 guests