Privi cases

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
User avatar
ovenpaa
Posts: 24689
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: Privi cases

#11 Post by ovenpaa »

Privi .308 brass is fine for reloading and I have found it quite robust in the past. If it was to be used for competition work I would probably sort it as well, weighing it and separating any extremes however for general club shooting just load and shoot the stuff. :p
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
Mezzer

Re: Privi cases

#12 Post by Mezzer »

Lev wrote:So the are the .308 good for reloads? I've heard differing reports on them.
I have quite a few I'm prepping at the moment.
Lev;

I use 308 and 303 cal cases from PPU for reloading and they are both fine. The brass is pretty reasonable.

Mezzer
Lev

Re: Privi cases

#13 Post by Lev »

Thanks guys.
Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests