Changing dies on a single stage press.

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
Alpha1
Posts: 8627
Joined: Fri Nov 12, 2010 8:27 pm
Contact:
Contact Alpha1

Re: Changing dies on a single stage press.

#21 Post by Alpha1 »

A Lyman crusher. Ill pm him to morrow and ask him.
Top
Blu

Re: Changing dies on a single stage press.

#22 Post by Blu »

Alpha1, If your press will take normal dies, (Hornady, RCBS, LEE, and such) then these will work for you.
Top
User avatar
Alpha1
Posts: 8627
Joined: Fri Nov 12, 2010 8:27 pm
Contact:
Contact Alpha1

Re: Changing dies on a single stage press.

#23 Post by Alpha1 »

Thanks blu they look interesting I might just invest in a couple of sets. You see its not true you can teach old dogs new tricks. lol
Top
Blu

Re: Changing dies on a single stage press.

#24 Post by Blu »

Alpha1, Hey you might want to shop around some before buying from JD reloading. Now I know kit is pricey in the UK but $37 is a bit much seeing as they sell here for $11. Just saying is all.
Top
User avatar
Alpha1
Posts: 8627
Joined: Fri Nov 12, 2010 8:27 pm
Contact:
Contact Alpha1

Re: Changing dies on a single stage press.

#25 Post by Alpha1 »

Ok blu Ill scour the net in the UK and see what comes up thanks for the heads up.
Top
Blu

Re: Changing dies on a single stage press.

#26 Post by Blu »

Here, all in the UK and cheaper than JD reloading.

http://www.opticswarehouse.co.uk/prodde ... es&cat=143

http://www.dauntseyguns.co.uk/proddetai ... ORN-044099

http://www.guns.gb.com/contents/en-uk/p ... n_kit.html
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: No registered users and 7 guests