Working up a load

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
WelshShooter
Full-Bore UK Supporter
Posts: 1812
Joined: Wed Jun 25, 2014 9:45 pm
Contact:
Contact WelshShooter

Re: Working up a load

#11 Post by WelshShooter »

I use 42.5gr of Ramshot Tac with a 155gr Lapua scenar in a 20" barrel. This load is half a grain higher than the starting load and prints amazing 5 shot groups at 100m (well to me anyway!) and is consistent at hitting fig11s at Sennybridge F range at 1000m. Not sure on velocity. Pic attached are two five shot groups at 100m. Image
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: No registered users and 2 guests