This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
i did think about drilling out the base to remove the majority of the brass then trying a hammer and screwdriver to mangle the rest out
No don't do that. Leave the die in your press screw the lock nut and de capper re sizing rod out of the die. find a short piece of metal rod that will go through your case mouth spray the whole thing with WD40 then knock it out with the rod and a hammer does not matter if you wreck the case saving the die is the important thing.
I don't know how you can get a 7.62x39 case stuck any way. Can you post some pictures.
