Anyone using .44 spl and HS6?

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
hobbesy
Posts: 630
Joined: Sat Jan 05, 2013 7:56 pm
Contact:
Contact hobbesy

Anyone using .44 spl and HS6?

#1 Post by hobbesy »

As the title says is anyone shooting .44 special with 240gn, .429, RNFP and using HS6 and how much powder you using and what groups you getting.

I'll be shooting them through a Winchester 94ae trapper 16"

cheers Rob
S&W M&P 15-22
Stoeger Sec 1
Adler a110 Sec 1
Winchester 94 .357,
Marlin 45-70
Savage 10 FP-SR .223
AI AE .308
.357 Westlake Alpha

Have slots open for.....
.22 LB pistol
.22LR rifle
Top
User avatar
phaedra1106
Posts: 3429
Joined: Wed Feb 08, 2012 9:37 pm
Location: Just outside Sacriston (the nice bit!)
Contact:
Contact phaedra1106

Re: Anyone using .44 spl and HS6?

#2 Post by phaedra1106 »

I use 5.4gr of TiteGroup for reduced loads in the 44mag with the 200grn LRNFP bullets and get very good results, low ES and it uses about half the powder you do with HS6.

Here's a link to some 44mag reduced loads using HS6, http://www.chuckhawks.com/hs6_44mag_reloads.htm
There's room for all Gods creatures, next to the mash and gravy :)
Top
hobbesy
Posts: 630
Joined: Sat Jan 05, 2013 7:56 pm
Contact:
Contact hobbesy

Re: Anyone using .44 spl and HS6?

#3 Post by hobbesy »

Thanks for the link, Hodgson load data is saying Start at 6.5gn and max is 8.0gn but your link is talking about starting at 10gns

More searching me thinks
S&W M&P 15-22
Stoeger Sec 1
Adler a110 Sec 1
Winchester 94 .357,
Marlin 45-70
Savage 10 FP-SR .223
AI AE .308
.357 Westlake Alpha

Have slots open for.....
.22 LB pistol
.22LR rifle
Top
User avatar
phaedra1106
Posts: 3429
Joined: Wed Feb 08, 2012 9:37 pm
Location: Just outside Sacriston (the nice bit!)
Contact:
Contact phaedra1106

Re: Anyone using .44 spl and HS6?

#4 Post by phaedra1106 »

As I said those are for reduced load 44mag, IMO a better option than using 44spl. 200gr shoot very nicely with reduced loads, using 5.4 of TiteGroup they were around 880fps with an ES of 13 in my Henry BigBoy. The 240gr with the same load drops to around 750fps with a larger ES.

If you've already got 44spl cases etc. then 6.5 to 7.5gr of HS6 will give around 760 to 870fps so nice enough to shoot all day for 25m gallery :good:
There's room for all Gods creatures, next to the mash and gravy :)
Top
hobbesy
Posts: 630
Joined: Sat Jan 05, 2013 7:56 pm
Contact:
Contact hobbesy

Re: Anyone using .44 spl and HS6?

#5 Post by hobbesy »

phaedra1106 wrote:As I said those are for reduced load 44mag, IMO a better option than using 44spl. 200gr shoot very nicely with reduced loads, using 5.4 of TiteGroup they were around 880fps with an ES of 13 in my Henry BigBoy. The 240gr with the same load drops to around 750fps with a larger ES.

If you've already got 44spl cases etc. then 6.5 to 7.5gr of HS6 will give around 760 to 870fps so nice enough to shoot all day for 25m gallery :good:
Sounds good, was using HS6 in my .38spl Rossi and was getting good groups. I also have two tubs of it so want to try it with the .44 before I go spending out more money on different powders.

I was given 100 rounds of .44 from a mate and they are very accurate (90-96 standing) I think he uses Tight-group but not 100%, sure he'll coment on here and put me right troutslapping

Just need to get time to load a few and try them out

thanks
S&W M&P 15-22
Stoeger Sec 1
Adler a110 Sec 1
Winchester 94 .357,
Marlin 45-70
Savage 10 FP-SR .223
AI AE .308
.357 Westlake Alpha

Have slots open for.....
.22 LB pistol
.22LR rifle
Top
User avatar
Sim G
Posts: 10752
Joined: Sat Nov 06, 2010 9:09 pm
Contact:
Contact Sim G

Re: Anyone using .44 spl and HS6?

#6 Post by Sim G »

hobbesy wrote: I was given 100 rounds of .44 from a mate and they are very accurate (90-96 standing) I think he uses Tight-group but not 100%, sure he'll coment on here and put me right troutslapping

6.0gns of Unique, 240gn LSWC.
In 1978 I was told by my grand dad that the secret to rifle accuracy is, a quality bullet, fired down a quality barrel..... How has that changed?

Guns dont kill people. Dads with pretty Daughters do...!
Top
hobbesy
Posts: 630
Joined: Sat Jan 05, 2013 7:56 pm
Contact:
Contact hobbesy

Re: Anyone using .44 spl and HS6?

#7 Post by hobbesy »

Told ya
S&W M&P 15-22
Stoeger Sec 1
Adler a110 Sec 1
Winchester 94 .357,
Marlin 45-70
Savage 10 FP-SR .223
AI AE .308
.357 Westlake Alpha

Have slots open for.....
.22 LB pistol
.22LR rifle
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: No registered users and 5 guests