So some of you might have seen in another thread that I've a Ruger GSR. It's got an 18" 1:10 twist barrel and shoots 1 moa with 168gr SMKs. This load is ok for a few shots buts the rifle is very light and if you did 50 or so shots prone you'd know about. I'm thinking of using either the 125 SMK or 135 SMK, anyone have an experience with these?
S
.308 Load for Ruger GSR
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
dromia
- Site Admin
- Posts: 20226
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: .308 Load for Ruger GSR
Cast boolits, way to go.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
-
Sandgroper
- Full-Bore UK Supporter
- Posts: 4735
- Joined: Sat Nov 06, 2010 3:45 pm
- Location: Stanley, Falkland Islands
- Contact:
Re: .308 Load for Ruger GSR
38.4 gn of H4895 with a 125gn bullet is what I used in my Ishapore scout rifle - very nice, easy shooting load.
“The standard you walk past is the standard you accept.”
Lieutenant General David Morrison
I plink, therefore I shoot.
Lieutenant General David Morrison
I plink, therefore I shoot.
-
saddler
Re: .308 Load for Ruger GSR
Some good .308 bullets available in lighter weights for the M1 Carbine. ..esp. 110 grain FMJ
For other options look to pistol weight bullets, plus as Dromia suggests pure lead bullets.
Other gallery loads can be made with round ball powered by pistol powders.
For other options look to pistol weight bullets, plus as Dromia suggests pure lead bullets.
Other gallery loads can be made with round ball powered by pistol powders.
-
Smudge
Re: .308 Load for Ruger GSR
saddler wrote:Some good .308 bullets available in lighter weights for the M1 Carbine. ..esp. 110 grain FMJ
For other options look to pistol weight bullets, plus as Dromia suggests pure lead bullets.
Other gallery loads can be made with round ball powered by pistol powders.
Thanks but I'm not looking at a gallery load, I really want a 300m reach.
S
-
dromia
- Site Admin
- Posts: 20226
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: .308 Load for Ruger GSR
Cast bullets 300 yrds with ease no special techniques required.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
-
tackb
Re: .308 Load for Ruger GSR
110 vmax shoots really well in my 308 either hand loaded or factory TAP ammo by hornady
-
Smudge
Re: .308 Load for Ruger GSR
I think you misunderstood me the M1 Carbine with 110gr is great but I never achieve much with the AR15 from SGC with a 1:10 twist barrel but that was for my gallery rifle shooting at my club range which has mv & me restrictions.saddler wrote:110grain .308 bullets will only travel 299 metres...my bad!
The rifle is now chambered in 300AAC and complies with all restrictions and shoots perfectly.
S
Who is online
Users browsing this forum: Bing [Bot] and 8 guests