7x33 Sako

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
Sim G
Posts: 10752
Joined: Sat Nov 06, 2010 9:09 pm
Contact:
Contact Sim G

Re: 7x33 Sako

#11 Post by Sim G »

dodgyrog wrote:Cleaning and photos tomorrow - give a chap a break Tony!
It's tomorrow!!!!
In 1978 I was told by my grand dad that the secret to rifle accuracy is, a quality bullet, fired down a quality barrel..... How has that changed?

Guns dont kill people. Dads with pretty Daughters do...!
Top
User avatar
dodgyrog
Posts: 4103
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:
Contact dodgyrog

Re: 7x33 Sako

#12 Post by dodgyrog »

Alpha1 wrote:
Dromia made a good suggestion today. He suggested getting a heavier boolit mould and remove some metal from it - probably a Loverin design.
In the absence of a suitable mould this seems the best way to go.
What do you mean by removing metal from it.
Mill some metal off of the top to reduce the boolit length and thus reduce its' weight.
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
Top
User avatar
Alpha1
Posts: 8627
Joined: Fri Nov 12, 2010 8:27 pm
Contact:
Contact Alpha1

Re: 7x33 Sako

#13 Post by Alpha1 »

Ah right I see simple enough to do but the boolit might be a bit odd shaped at the base.
Top
User avatar
dodgyrog
Posts: 4103
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:
Contact dodgyrog

Re: 7x33 Sako

#14 Post by dodgyrog »

Alpha1 wrote:Ah right I see simple enough to do but the boolit might be a bit odd shaped at the base.
You'll never know with my boolits. lol
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
Top
User avatar
dodgyrog
Posts: 4103
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:
Contact dodgyrog

Re: 7x33 Sako

#15 Post by dodgyrog »

Sorry, no photo yet - lots of boolits on the go.
I saw a 30 AAC Blackout round today (one of Phaedra's) - there's absolutely no difference between that and the 7x33 apart for .020" on bullet diameter and a couple of thou on the case head. There's nothing new.
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
Top
User avatar
phaedra1106
Posts: 3429
Joined: Wed Feb 08, 2012 9:37 pm
Location: Just outside Sacriston (the nice bit!)
Contact:
Contact phaedra1106

Re: 7x33 Sako

#16 Post by phaedra1106 »

Are we comparing sizes? :oops:
There's room for all Gods creatures, next to the mash and gravy :)
Top
User avatar
dodgyrog
Posts: 4103
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:
Contact dodgyrog

Re: 7x33 Sako

#17 Post by dodgyrog »

phaedra1106 wrote:Are we comparing sizes? :oops:
You couldn't compete! phnar phnar
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
Top
User avatar
phaedra1106
Posts: 3429
Joined: Wed Feb 08, 2012 9:37 pm
Location: Just outside Sacriston (the nice bit!)
Contact:
Contact phaedra1106

Re: 7x33 Sako

#18 Post by phaedra1106 »

Oooh Errrr!!!!

I do have size 13 feet if that helps :grin:
There's room for all Gods creatures, next to the mash and gravy :)
Top
User avatar
dodgyrog
Posts: 4103
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:
Contact dodgyrog

Re: 7x33 Sako

#19 Post by dodgyrog »

phaedra1106 wrote:Oooh Errrr!!!!

I do have size 13 feet if that helps :grin:
Matches the hat size! troutslapping
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: Google [Bot] and 3 guests