Counting things ...

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
Magpie

Re: Counting things ...

#11 Post by Magpie »

Ohh Errr, bit technical for me, but they sound expensive :-)
rox
Posts: 1900
Joined: Fri Dec 10, 2010 1:33 pm
Contact:

Re: Counting things ...

#12 Post by rox »

Magpie wrote:Ohh Errr, bit technical for me, but they sound expensive :-)
They are a bit. Like the bicycle builder said: Strong, Light, Cheap – pick any two, but for digital balances it’s something like: Fast (settle time), Sensitive, Stable, High-resolution, Cheap – pick any four. Lots of people get great results with strain-gauge balances though, so as long as your measurement technique is good and expectations reasonable they can do the job very well.

..
Magpie

Re: Counting things ...

#13 Post by Magpie »

Yeah, you get what you pay for I guess (well if you're lucky). The gem pros are pretty good so far. The important thing for me is repeatability. If I weigh a bullet, I want it to have the same weight 10 minutes later. I had some lymans ones, but they weren't accurate enough +/- .1 grain is not good for me (should have read the small print ) gempro read to .02 grain
Not so worried about absolute accuracy. As long as the same weight of powder always gives the same reading that should be good enough. Since our start load is somethng like 10% under max, that should leave plenty of leeway.
Magpie

Re: Counting things ...

#14 Post by Magpie »

Hi Rox

I'm looking at these two as contenders at the moment
http://www.ebay.co.uk/itm/833172-Home-D ... 3f26e23ccc

http://www.amazon.co.uk/DIGITAL-POSTAL- ... n+counting

The first ones I'm probably more inclined to go with at the moment unless anything better shows up
rox
Posts: 1900
Joined: Fri Dec 10, 2010 1:33 pm
Contact:

Re: Counting things ...

#15 Post by rox »

Magpie wrote:I'm sure you all at onetime or another have the need to count things like cases or bullets for batching etc.
...
I've seen that you can get counting scales where you weigh one of the thing and then put a bunch on and it works out how many there are based on the weight of the bunch and the unit item weight.

Has anybody got any experience of using one of these ?

Just took delivery of an Adam CBC8 counting balance. First impressions are that it's very good for use as a reloader's counting balance.

http://www.adamequipment.co.uk/eu/balances/96

Image


The 8Kg capacity will handle about 700 .308 cases, 800 155gr bullets, 600 200gr bullets, and the balance has a resolution of 0.2 grams so it's useful for general weighing duty (but not for powder charges or component batching, of course). The size of the pan is large enough for the kind of containers that would hold 500 cases. It's very easy to use:
  • Zero the balance and/or tare the container.
  • Place a known quantity of items in the container, and enter the quantity using the numeric keypad.
  • Place the items to be counted in the container.
The displays indicate the total weight, individual item weight and count.

Brief initial testing found it to be accurate for quantities of 200 to 300 .308 cases. On counting a known quantity of 583 .308 cases I did see an error of 1 either way - this might be improved by using a larger sample to get a better average (I used 10 cases), or perhaps there is just too much variation in case weights to get perfectly accurate counts of more than about 300 cases. Despite this it's a very useful tool that will come in very handy when making larger batches.


..
waterford103
Posts: 1076
Joined: Fri Feb 01, 2013 3:34 pm
Home club or Range: Aberdeen FBGC
Location: North-East Scotland
Contact:

Re: Counting things ...

#16 Post by waterford103 »

meles meles wrote:can you still get the dilithium crystals for those?
mr spock keeps them locked away clapclap
"This year will go down in history. For the first time, a civilized nation has full gun registration. Our streets will be safer, our police more efficient, and the world will follow our lead into the future!"
Adolph Hitler – 1933
Magpie

Re: Counting things ...

#17 Post by Magpie »

Hi rox,

could I be cheeky and ask how much?
the website seems not to have pricing. I did get the one I was looking at - in fact I had three of them before I called time on it and asked for my cash back.
The first one would reset it self when you put more cases on, so I was looking to batch in 50's and as i was dropping in a few at a time it would just reset.
The second one only showed an error code after the first batch of things it weighed.
The third one was the same as the first although it did work properly for about half an hour.
rox
Posts: 1900
Joined: Fri Dec 10, 2010 1:33 pm
Contact:

Re: Counting things ...

#18 Post by rox »

Magpie wrote:could I be cheeky and ask how much?.
It was a bit, erm, pricier than the eBay ones (but it works!).
Including VAT, delivery, Credit card surcharge, it was a fraction over £200.00.

..
Magpie

Re: Counting things ...

#19 Post by Magpie »

rox wrote:
Magpie wrote:could I be cheeky and ask how much?.
It was a bit, erm, pricier than the eBay ones (but it works!).
Including VAT, delivery, Credit card surcharge, it was a fraction over £200.00.

..
Ouch .... my pockets aren't that deep :squirrel:

I guess my search will go on .......
I did start looking at this one
http://www.ebay.co.uk/itm/NEW-DIGITAL-C ... 1c2f468723

but its still more than I really wanted to pay. but the cheap ones seem to suffer from not working :cry:
Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests