Forster Coaxial Press
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
TJC
Re: Forster Coaxial Press
Quite happy with mine. No complaints but i do suspect the quality of my reloads wouldn't suffer if i used the Rock Chucker. If you are seriously into producing high quality, consistent reloads then it is probably worth the money but if you aren't then it might be a bit of a luxury.
-
DaveT
Re: Forster Coaxial Press
Co-ax for me every time...just slip the preset die in place and away you go.
-
dodgyrog
- Posts: 4103
- Joined: Wed Jan 05, 2011 11:17 pm
- Home club or Range: Three Counties Sporting Club & Gardners Guns
- Location: Consett, County Durham
- Contact:
Re: Forster Coaxial Press
Apart from the co-ax I have several Dillons.
The co-ax is so easy to set up and the full length die seems to go further down the case which means easier chambering in the rifle. Previously I had to push through the cases of 'acquired' brass (bin raiding!!!) through a modified carbide 45ACP die to iron out the last 1/8 inch of case expansion near the case head.
Also swapping dies is so quick and easy.
The co-ax is so easy to set up and the full length die seems to go further down the case which means easier chambering in the rifle. Previously I had to push through the cases of 'acquired' brass (bin raiding!!!) through a modified carbide 45ACP die to iron out the last 1/8 inch of case expansion near the case head.
Also swapping dies is so quick and easy.
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
All round good guy and VERY grumpy old man.
Who is online
Users browsing this forum: Bing [Bot], Google [Bot] and 7 guests