Hi there,
I’m asking this question on behave of a friend who is not on the net, and being a noob I’m not up to speed on reloading, so please forgive me if the info is already here somewhere!
Is there a start load and a DNE load for .308 Lapua brass, with Lapua scenar 155grain bullets?
Many thanks
TR140 basic info
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
johngarnett
- Full-Bore UK Supporter
- Posts: 776
- Joined: Mon Dec 06, 2010 1:28 pm
- Home club or Range: Cornwall RC @ Millpool; Duchy Shooting Assn @ Zelah
- Location: Cornwall
- Contact:
Re: TR140 basic info
If you do a search on this forum for 'TR140' you'll find some good info re loads etc.
I did and got all I needed!
Good luck
JohnG :cornwall:
I did and got all I needed!
Good luck
JohnG :cornwall:
-
Col
Re: TR140 basic info
Any one know of a supplier in South Wales area for TR140. or the manufactorer please
Re: TR140 basic info
I would suggest dropping down at least a couple of grains and move up
Re: TR140 basic info
I have a lot more information on the TR140 loads I can dig out if you get stuck, it is on another machine or I would post it now.
-
Yogi GunKanobee
Re: TR140 basic info
Thank you, I gave the chart to my friend. I think he would appreciate as much info as possible, if it's not too much trouble.ovenpaa wrote:I have a lot more information on the TR140 loads I can dig out if you get stuck, it is on another machine or I would post it now.
Who is online
Users browsing this forum: No registered users and 7 guests