Bullet stabilisation
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
dromia
- Site Admin
- Posts: 20225
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Bullet stabilisation
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
-
phaedra1106
- Posts: 3429
- Joined: Wed Feb 08, 2012 9:37 pm
- Location: Just outside Sacriston (the nice bit!)
- Contact:
Re: Bullet stabilisation
I found that the 168gr A-Max, Nosler CC and Lapua Scenar (very similar profiles) would not stabilise from my Steyr (23.6" 1-10 twist) and I had some keyholes at 100m. Cast lead 160gr round nose flat points however work very nicely (As supplied by Dodgyrog) 
Last edited by phaedra1106 on Sun Feb 17, 2013 6:06 pm, edited 1 time in total.
There's room for all Gods creatures, next to the mash and gravy :)
-
dodgyrog
- Posts: 4103
- Joined: Wed Jan 05, 2011 11:17 pm
- Home club or Range: Three Counties Sporting Club & Gardners Guns
- Location: Consett, County Durham
- Contact:
Re: Bullet stabilisation
Only if I make them.phaedra1106 wrote:I found that the 168gr A-Max, Nosler CC and Lapua Scenar (very similar profiles) would not stabilise from my Steyr (23.6" 1-10 twist) and I had some keyholes at 100m. Cast lead 160gr round nose flat points however work very nicely.
sign92 
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
All round good guy and VERY grumpy old man.
-
meles meles
- Posts: 6335
- Joined: Mon Jun 06, 2011 8:17 pm
- Home club or Range: HBSA
- Location: Underground
- Contact:
Re: Bullet stabilisation
dromia wrote:
We assume you now work as a steak tenderiser for Sainsbuggers...
Badger
CEO (Chief Excavatin' Officer)
Badger Korporashun
Quidquid latine dictum sit altum viditur.
"Quelle style, so British"
CEO (Chief Excavatin' Officer)
Badger Korporashun
Quidquid latine dictum sit altum viditur.
"Quelle style, so British"
-
dromia
- Site Admin
- Posts: 20225
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Bullet stabilisation
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
-
phaedra1106
- Posts: 3429
- Joined: Wed Feb 08, 2012 9:37 pm
- Location: Just outside Sacriston (the nice bit!)
- Contact:
Re: Bullet stabilisation
Well he has been known to "beat his meat" on occasion . . . . . . .meles meles wrote:We assume you now work as a steak tenderiser for Sainsbuggers...
There's room for all Gods creatures, next to the mash and gravy :)
-
meles meles
- Posts: 6335
- Joined: Mon Jun 06, 2011 8:17 pm
- Home club or Range: HBSA
- Location: Underground
- Contact:
Re: Bullet stabilisation
Hmmm, if this thread sinks any lower you'll be needing a visa to enter our territory....
Badger
CEO (Chief Excavatin' Officer)
Badger Korporashun
Quidquid latine dictum sit altum viditur.
"Quelle style, so British"
CEO (Chief Excavatin' Officer)
Badger Korporashun
Quidquid latine dictum sit altum viditur.
"Quelle style, so British"
-
meles meles
- Posts: 6335
- Joined: Mon Jun 06, 2011 8:17 pm
- Home club or Range: HBSA
- Location: Underground
- Contact:
Re: Bullet stabilisation
Right, bald monkeys, back on subject. We were hoping if it would be possible to shoot supersonic milsurp 6.5x55 and, bigger, longer, heavier, cast lead, sub-sonic boolits, from the same barrel. Is it ?
Badger
CEO (Chief Excavatin' Officer)
Badger Korporashun
Quidquid latine dictum sit altum viditur.
"Quelle style, so British"
CEO (Chief Excavatin' Officer)
Badger Korporashun
Quidquid latine dictum sit altum viditur.
"Quelle style, so British"
-
dromia
- Site Admin
- Posts: 20225
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Bullet stabilisation
What distances for the sub sonic load to be shot at?
Boolit weight, you'll be lucky to get much heavier than 165 gns as the throat length will limit boolit length as that is the only way you can go to increase weight, Oldfellers Cruise Missile design is about as heavy as you will get and it comes out at around 165-170 depending on mould and alloy, also if you are lucky enough to have a worn throat then you can increase the diameter somewhat giving a little more weight. My Swedes shoot 0.269" diameter boolits ranging from 120gn to 170gn designs. The 120gn is good out to 300yrds but its launched at around 1500fps. The Cruise Missile goes out at nigh on 2000 fps but that takes some work as with the fast twist in the Swedes getting over 1600 fps with cast boolits and accuracy is the PHd of cast boolit shooting.
Boolit weight, you'll be lucky to get much heavier than 165 gns as the throat length will limit boolit length as that is the only way you can go to increase weight, Oldfellers Cruise Missile design is about as heavy as you will get and it comes out at around 165-170 depending on mould and alloy, also if you are lucky enough to have a worn throat then you can increase the diameter somewhat giving a little more weight. My Swedes shoot 0.269" diameter boolits ranging from 120gn to 170gn designs. The 120gn is good out to 300yrds but its launched at around 1500fps. The Cruise Missile goes out at nigh on 2000 fps but that takes some work as with the fast twist in the Swedes getting over 1600 fps with cast boolits and accuracy is the PHd of cast boolit shooting.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
-
dromia
- Site Admin
- Posts: 20225
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Bullet stabilisation
BTW your mate Sandgroper has one of the orignial Oldfeller Cruise Missile moulds.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
Who is online
Users browsing this forum: Bing [Bot] and 14 guests