Stainless bar stock

Anything non shooting related wanted.

Moderator: dromia

Forum rules
All groups are welcome to post unless your user name is in Newly Registered Red, your post will be removed.
No disparaging remarks, if you don't like what you see then don't buy it.
Post Reply
Message
Author
User avatar
Alpha1
Site Supporter Since 2020
Posts: 8553
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Stainless bar stock

#1 Post by Alpha1 »

I'm after a piece of stainless round bar stock about a 1-1/4" OD and about 4" long.
Andy632
Posts: 951
Joined: Thu Oct 13, 2011 9:36 am
Home club or Range: Strathpeffer Rifle & Pistol Club (& Cawdor Rifle Club)
Location: Highlands

Re: Stainless bar stock

#2 Post by Andy632 »

Alpha1 wrote:I'm after a piece of stainless round bar stock about a 1-1/4" OD and about 4" long.

Lots of it (303) but I'm in the Highlands.
Rifle & Pistol Shooting in the Highlands with Strathpeffer Rifle & Pistol Club.
User avatar
Alpha1
Site Supporter Since 2020
Posts: 8553
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Re: Stainless bar stock

#3 Post by Alpha1 »

Hmm I think Ill ring a local steel stockists in the morning I think they sell 3m lengths. My guess is they will charge me a arm and a leg.
User avatar
Ovenpaa
Site Supporter Since 2015
Posts: 24680
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: Stainless bar stock

#4 Post by Ovenpaa »

Would a length of stainless rifle barrel be of use? Just not sure if I have any as big as 32 mm as I tend to chop the chamber ends for sectioning
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
User avatar
Alpha1
Site Supporter Since 2020
Posts: 8553
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Re: Stainless bar stock

#5 Post by Alpha1 »

I want it to make a 38/357 case holder for the LeWilson trimmer if the bore is small enough I could open it up. The OD of the Wilson case holders is 26mm.
Andy632
Posts: 951
Joined: Thu Oct 13, 2011 9:36 am
Home club or Range: Strathpeffer Rifle & Pistol Club (& Cawdor Rifle Club)
Location: Highlands

Re: Stainless bar stock

#6 Post by Andy632 »

Alpha1 wrote:Hmm I think Ill ring a local steel stockists in the morning I think they sell 3m lengths. My guess is they will charge me a arm and a leg.

Check out any Marine workshops.

If stuck I can post you a bit, just need the postage.
Rifle & Pistol Shooting in the Highlands with Strathpeffer Rifle & Pistol Club.
Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests