Which Hornady shell plate for .310 Cadet?

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
ultonia
Posts: 16
Joined: Sun Dec 10, 2017 8:17 pm
Location: Surrey
Contact:

Which Hornady shell plate for .310 Cadet?

#1 Post by ultonia »

Can’t find the recommended shell plate for .310 cadet on Hornady chart or elsewhere online. Can someone point me in the right direction please?
FredB
Site Supporter Since 2019
Posts: 969
Joined: Fri Dec 10, 2010 8:33 pm
Home club or Range: stourport
Location: Wolverhampton
Contact:

Re: Which Hornady shell plate for .310 Cadet?

#2 Post by FredB »

I don't know the hornady numbering sequence, but it is a Lee number 6, the same as use for 9mm.
Fred
User avatar
Alpha1
Site Supporter Since 2020
Posts: 8553
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Re: Which Hornady shell plate for .310 Cadet?

#3 Post by Alpha1 »

Are you talking about a shell plate or a shell holder?
ultonia
Posts: 16
Joined: Sun Dec 10, 2017 8:17 pm
Location: Surrey
Contact:

Re: Which Hornady shell plate for .310 Cadet?

#4 Post by ultonia »

I already have the shell holder which came with the dies. I was going to set up a Hornady progressive press to load .310 Cadet, so I'd need a shell plate to suit.
Post Reply

Who is online

Users browsing this forum: No registered users and 12 guests