Help needed to identify some bits and bobs

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
glevum
Past Supporter
Posts: 213
Joined: Wed Oct 05, 2016 3:45 pm
Home club or Range: Cotswold Rifle Club
Contact:

Re: Help needed to identify some bits and bobs

#11 Post by glevum »

User avatar
Dellboy
Site Supporter 2021
Posts: 2617
Joined: Wed Aug 31, 2011 11:49 am
Home club or Range: Star Shooting Club
Location: Essex
Contact:

Re: Help needed to identify some bits and bobs

#12 Post by Dellboy »


I have a good few ready to go really dont need to buy or make any .
2020 GOOD DEALS WITH

Cutch Vortex Scope
Mauserbill Enfield Books


Enjoy today as tomorrow might not come .

Noli pati a scelestis opprimi.

002515
Post Reply

Who is online

Users browsing this forum: No registered users and 12 guests