P14 Target Rifle Owners

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
Dahonis

P14 Target Rifle Owners

#1 Post by Dahonis »

Hi,

I have a P14 with a target barrel built by Norman Clarke in 7.62x51.

I've had some excellent advice from Dromia on types of cast boolit that may work.

But, does anyone who has one shoot cast bullets 'in it? any????

It has a very short throat and the only boolit that chambers is the Lee C309-160gr.

If I go any extra grains wise the boolit seats below the case neck just to get it to chamber....I now know this is not a massive problem (cheers Dromia).

My shooting will be up to 300m, so the Lee mold is ok, but anyone use anything else!

Kind Regards

Chris
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: No registered users and 9 guests