tr 140

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
Rburro2
Posts: 769
Joined: Tue Nov 13, 2012 7:56 pm
Home club or Range: Uttoxeter rifle club

tr 140

#1 Post by Rburro2 »

Hi there im after some load data for tr 140
rws .308 cases
150 grn sierra match kings
cci large rifle primmers
Any advice much appreciated
GazMorris
Posts: 316
Joined: Fri Apr 13, 2012 8:51 am

Re: tr 140

#2 Post by GazMorris »

Rburro2 wrote:Hi there im after some load data for tr 140
rws .308 cases
150 grn sierra match kings
cci large rifle primmers
Any advice much appreciated
Hi Rburro,

I've never used the 150s (I always use 155s, both the Sierra old-style 2155 and new-style 2156) but the loads should be reasonably similar for the same rifle. I use 45.0grn for 300 to 600 yards and 46.5grn for 900 and 1000 yards with Sierra 155s in RUAG Cases with Federal 210 match primers.

NB - I weigh every charge and these loads are safe in my rifle, back off at least 5% and work up loads which are safe in your rifle.

Cheers,

Gaz
Post Reply

Who is online

Users browsing this forum: No registered users and 10 guests